D4V-8166Z Coil Spring Rod Limit Switch Handles Off-Center Targets

Oct 28, 2026

Leave a message

The D4V-8166Z is the flexible-rod option in the D4V actuator range. It is a coil spring rod limit switch for targets that arrive slightly off-center. Where a fixed lever slides past the workpiece, this travel limit switch still trips.

 

Why a fixed lever falls short

Roller levers and push plungers have to meet the workpiece at one set point. When the stop drifts or the part sits low, the contact may not trip. A mechanic then reworks the bracket after every changeover. On a mechanical limit switch the actuator carries that burden: a rigid lever leaves little tolerance for drift, a coil spring actuator gives some back.

 

What changes on the D4V-8166Z

The D4V-8166Z swaps the lever for a coil spring actuator: a thin rod that bends as the moving part passes. The contacts can still trip when the target arrives a little off-center, and that wider area saves bracket work after a changeover. No sensor or target needs fitting to the moving part, because this mechanical limit switch works on physical contact. The housing is zinc alloy, the contacts are silver, the seal is IP65. Treat the rod as a contact element rather than a hard stop, and keep the touch light.

 

Key specifications

Electrical life: 500,000 operations minimum

Operation force: up to 150 g

Pre-travel: up to 30 mm

Ambient temperature: −20 °C to +70 °C, no icing

Protection: IP65

Certifications: CE, CB, CCC, CQC, RoHS

Pre-travel is capped at 30 mm, so on this coil spring rod limit switch the trip point depends on where the rod meets the workpiece. That is the figure to watch when sizing a travel limit switch for a long-stroke axis.

 

Where it fits

Conveyor jam detection is the usual job for this travel limit switch. When material backs up and pushes the rod, the contact trips and the controller stops the line. On bulk material transfer machines the rod meets solid material directly, not a fixed target. Uneven workpiece position sensing is where the flexible head pays off: parts at different heights still reach the rod. The same coil spring rod limit switch covers flexible stroke inspection and auto door over-travel protection. Agricultural processing machinery is the other common spot, where the IP65 housing matters.

 

Choosing between actuators

The D4V-8166Z sits in the D4V series next to the roller lever and push plunger versions. Pick this travel limit switch when the target drifts, approaches at an angle, or is hard to reach. Where the stop is fixed and repeatable, a roller lever is usually the simpler fit. Pre-travel on this mechanical limit switch is rated to 30 mm. Contact us for drawings, samples or pricing of this coil spring actuator.

 

D4V-8166Z Coil Spring Rod Limit Switch

Send Inquiry