The travel switch is a device that controls the termination position of motor movement, which is often used in the mechanical movement of rolling shutter door and elevator The following describes the installation and use of the travel switch:
1. Installation method of travel switch
When installing the limit switch, it is necessary to select the appropriate installation position and connect it correctly according to the wiring method in the instruction manual. Here are the steps:
1.Select the installation position to ensure that the limit wheel of the travel switch can smoothly contact the position that needs to be stopped.
2.Fix the travel switch in the selected position, and pay special attention to the firmness and stability of the installation.
3. Connect the circuit between the travel switch and the motor controller according to the wiring method in the instruction.
2. Use method of travel switch
After the correct installation of the travel switch, the parameters of the travel switch need to be set correctly to ensure that the motor works normally and meets the required limits. Here are the steps:
1. Open the parameter setting interface of the motor controller, find the corresponding travel switch configuration option and open it.
2. Adjust the parameters such as the limit position and action mode when the switch is triggered according to actual requirements, and save them.
3. Test whether the motor movement reaches the preset limit position. If it is not in place, adjust it accordingly until it meet the requirement.
