New Release: XCE Style Compact Limit Switch

Nov 14, 2026

Leave a message

The XCE style limit switch comes with a range of group-based interchangeable actuators. Its 28 mm plastic-and-metal housing fits well where mounting brackets are tight for space. For this compact limit switch, the slim 28 mm body brings clear benefits when space around the cam is limited.

Housing and Wiring

The body of this compact limit switch measures 28 mm across. A rubber cable gland accepts cables with outer diameters from 6 mm to 9 mm, and screw-clamp terminals work with conductors up to 1.5 mm²; standard hand tools are sufficient for on-site wiring. It carries an IP65 rating: it stands up to dust and splashing water, though it cannot withstand immersion.

Contacts and Ratings

Contacts are 1NO+1NC with snap action, so changeover completes in one movement. Conventional thermal current is 10 A; utilization ratings are AC-15 at 240 VAC, 3 A and DC-13 at 220 VDC, 0.3 A. Always size your load against the utilization category rather than thermal current alone, an important point when applying this compact limit switch. For relay-coil or small-contactor loads, the DC-13 rating will tell you whether the XCE style limit switch fits your circuit.

 

Selection Guide

The actuator decides whether a travel limit switch follows the cam path cleanly. Actuators are divided into three groups. Interchangeability is supported within the same group, while cross-group replacement is not available.

 Plunger. Top plunger (XCE110C) for direct vertical contact. Roller plunger (XCE102C) where the cam slides in sideways and the roller takes the wear. Cross roller plunger (XCE103C) for approaches from either side.

 Roller lever. Fixed short (XCE118C) for tight layouts; fixed long (XCE145C) to reach a cam further away; adjustable (XCE146C) when length is trimmed on site.

 Flexible rod. Straight wire rod (XCE154C) for offset moving parts; spring coil rod (XCE106C) to absorb small misalignment; flexible spring rod (XCE181C) where movement is irregular.

All nine variants share the same 28 mm housing footprint. When switching between actuator styles within the same group, the existing mounting bracket can be reused. That is the difference from a unit with one fixed actuator, and why one drawing covers this compact limit switch range.

 

Where It Is Used

Typical installations: packaging machinery, conveyor lines, woodworking machines, metal processing equipment, injection molders, automated assembly lines. In each, the compact limit switch handles position detection, travel limit and end-stop sensing. A travel limit switch of this width earns its place on conveyor side rails and inside guard frames, where a wider housing would sit closer to the moving part.

 

Supply and Documentation

Production follows standardized procedures with routine sample verification, and bulk quantities of the compact limit switch are supported. Datasheets and specification documents for the XCE style limit switch are supplied for selection, plus after-sales support. Model codes above identify the actuator version to order.

 

XCE Style Compact Limit Switch

 

Send Inquiry