Panasonic TB118N

Timer technical parameter:

The Panasonic TB118N can be widely used in neon lights, water heaters, street lamps, stair lights, breeding, garden watering, motors, advertising boxes, office facilities and other occasions where civil or industrial electricity needs to be controlled on time. Panasonic TB118N can be automatically controlled according to the required time.

· Working power supply voltage 100-240VAC universal

· Allowed operating voltage range 85-264VAC

· Power supply frequency 50Hz/60Hz universal

· Drive mode quartz motor

· Power outage compensation 300 hours (built-in nichCR battery)

· Monthly difference of time accuracy within +/-15 seconds (at ambient temperature of 25C)

· Operating time accuracy within +/-7.5 points (excluding initial time adjustment errors)

· The cycle is 24 hours

· Consumption power 110VAC1W220VAC2W

· Output circuit number 1

- The circuit constitutes the same circuit (with voltage contact output)

· The contact constitutes a single pole single input

· Automatic on/off with open/close transfer switch

· Contact capacity resistance 15A White heat lamp 15A reactance (cos0)=0.7)12A

· Motor (cosCM).7)110VAC750W 220VAC1500W

· Set action time mode set handle insert, disengage · Minimum unit 15 minutes

· Minimum interval 30 minutes

· Standard 6 actions, maximum 48 actions

· Ambient temperature -10°C~+5(TC

· The ambient humidity is below 85%

· Weight 260g

Installation method:

Remove the protective cover and secure it in the mounting hole with a 25mm wooden bolt or M4 bolt. When installing it in parallel with other devices, leave space for the protective cover to open and close freely.

Wiring method

Suitable wire (please use 600V plastic insulated wire)

Single line...

Twisted wire... 1.25 2 mm

Nickel chromium battery exchange method

The life of the battery is about 5 years, the higher the use of temperature, the life will be more shortened, so please replace the battery in advance, please be sure to cut off the power when replacing the battery to operate, no danger of electric shock.

Action moment setting

Please set the setting handle to the desired moment.

Insert the setting handle into the desired mark on the dial.

Insert the red setting handle at the moment you wish to power on.

Insert the inner color setting handle when you want to turn off the power.

Be sure to insert the setting handle firmly into it.

In addition, the power - on setting handle and power - off setting handle must be set alternately.

The occasion in the picture below

Power on at 12 o 'clock, off at 14 o 'clock, on at 14.30, off at 15 o 'clock

The setting of the present moment, rotate the dial in the direction of the arrow (right) so that the present moment display is partially aligned with the desired moment on the dial.

Be sure to rotate the dial in the direction indicated by the arrow. Forced directional rotation can be a cause of failure.

Use the on/off switch button to set the on/off state of load.

The switch button can be used to confirm the on/off state and switch the on/off state.

After connecting the circuit wiring, please use the switch button for test operation.

Note:Please rotate the switch button in the direction indicated by the arrow. After the switch, please determine the on/off state of the switch button according to the setting state of the setting handle.

Do not operate the switch button on/off when the setting handle is in the display part of the present time within about 1 hour, otherwise it will be the cause of failure.

For long time continuous on (or off) occasions, please remove all the setting handle from the dial before setting the switch button.